Diehaak tipe skietblaasmasjienhet gewoonlik 'n groter voorkoms, en die installasieproses is relatief ingewikkelder as dié van klein toerusting. Die korrekte installasie en toetsmasjien is die sleutel tot die normale werking van die latere toerusting. In die geval van ongeskoolde aanvanklike operasies, moet gebruikers die instruksies van relevante personeel streng volg of na die instruksies verwys. Ongemagtigde werking kan maklik onomkeerbare skade aan diehaak geskiet skietmasjien. Dieshot blasting machine manufacturer has sorted out the precautions for installation and test machine to share with you. I hope it will be helpful to users who use the device for the first time.
1. Installation. Diehaak tipe skietblaasmasjien is installed and debugged in the production plant and disassembled into several parts before being transported to the user site for installation. Although there is no pit, the foundation must be firm, the anchor bolt holes must be standardized, and the chamber body must be adjusted. After the second irrigation, the anchor bolt nuts can be tightened after solidification. After the chamber body is fixed, the various parts can be installed. Dieprecautions for the installation and debugging of the relevant components are introduced below.
1. Skietblaasapparaat:
Dieshot blasting device has been installed on the chamber body before leaving the factory. Please pay attention to the problems to be debugged before use. Check whether the fixed positions of the blade, the pill wheel, the directional sleeve, and the guard plate are accurate and firm, and check whether the direction of rotation is correct after power on. Then adjust the position of the directional sleeve opening. Theoretically, the angle between the front edge of the directional opening and the front edge of the blade throwing position is about 900. After fixing the position of the directional sleeve, the position of the projectile belt can be detected by hanging Place a steel plate or wooden board on the position of the workpiece facing the exit of the shot blasting machine, start the shot blasting machine, put a small amount (2-5kg) of projectiles into the blasting tube, and then stop, check whether the hit position on the steel plate is suitable for the needs, such as Close the window of the bias-adjustable directional sleeve downwards, and vice versa, until it fits, and note the position of the directional sleeve opening as a basis for future replacement of the directional sleeve.
2. Hys- en skroeftransporteur:
Doen eers 'n no-load-toets om te kyk of die hysbak en die spiraalblaaie in die regte rigting loop, trek dan die gordel met 'n matige spanning vas om afwyking te voorkom, en voer dan 'n ladingstoets uit om te kontroleer die werking en vervoervermoë, of daar vreemdheid is Raas en vibrasie, kyk en verwyder hindernisse.
3. Pil-sand skeier:
Kontroleer eers of die beweging van die ram buigbaar is, en kontroleer dan die regte posisie van die skeidingsplaat, en as die takel gelaai en ontfout word, is daar 'n deurlopende invloei van staalskote en kyk of die staalskote uitloop en val wanneer die skyf ontslaan word